Nissan 2011 Cube User Manual download pdf (Page 48)

Black plate (44,1)

Model "Z12-D" EDITED: 2010/ 9/ 27

SSS0650

Rear-facing — step 4

4. After attaching the child restraint, test it

before you place the child in it. Push it from

side to side while holding the child restraint

near the LATCH attachment path. The child

restraint should not move more than 1 inch

(25 mm), from side to side. Try to tug it

forward and check to see if the LATCH

attachment holds the restraint in place. If the

restraint is not secure, tighten the LATCH

attachment as necessary, or put the restraint

in another seat and test it again. You may

need to try a different child restraint or try

installing by using the vehicle seat belt (if

applicable). Not all child restraints fit in all

types of vehicles.

5. Check to make sure the child restraint is

properly secured prior to each use. If the

child restraint is loose, repeat steps 1

through 4.

SSS0100

REAR-FACING CHILD RESTRAINT IN-

STALLATION USING THE SEAT BELTS

WARNING

. The three-point seat belt with Auto-

matic Locking Retractor (ALR) must

be used when installing a child

restraint. Failure to use the ALR

mode will result in the child re-

straint not being properly secured.

The restraint could tip over or be

loose and cause injury to a child in a

sudden stop or collision. Also, it can

change the operation of the front

1-30 Safety — Seats, seat belts and supplemental restraint system

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 344 345

No comments

Nissan 2011 Cube User Manual Page 48