Nissan 2011 Cube User Manual download pdf (Page 327)

Black plate (325,1)

Model "Z12-D" EDITED: 2010/ 9/ 27

FOR Kro

m MODELS

Use the following steps to mount the license

plate:

Before mounting the license plate, confirm that

the following parts are enclosed in the vinyl bag.

. License plate bracket

. J-nut 6 2

. Screw 6 4

. Screw grommet 6 4

1. Park the vehicle on flat, level ground.

2. Temporarily place the license plate bracket

while aligning points

of the front bumper

fascia with holes

in the license plate

bracket.

3. Confirm that points

and

are aligned.

Hold the license plate bracket and mark the

points

on the bumper facia through the

center of the holes

with a felt-tip pen.

4. Remove the license plate bracket.

5. Carefully drill two shallow pilot holes

and

using a 0.39 in (10 mm) drill bit at

the marked locations. (Be sure that the

drill only goes through the fascia, or

damage to the nut may occur.)

6. Insert grommets into the hole on the fascia.

7. Insert a flat-blade screwdriver into the

grommet hole to add a 908 turn onto the

part

8. Insert a J-nut into the license plate bracket

before placing the license plate bracket on

the fascia.

9. Install the license plate bracket with the

screws.

10. Install the license plate with bolts that are

not longer than 0.55 in (14 mm).

Technical and consumer information 9-13

1 2 ... 322 323 324 325 326 327 328 329 330 331 332 ... 344 345

Comments to this Manuals

No comments

Nissan 2011 Cube User Manual Page 327

Comments to this Manuals

Related products and manuals for Cars Nissan 2011 Cube