Nissan 2011 Cube User Manual download pdf (Page 325)

Black plate (323,1)

Model "Z12-D" EDITED: 2010/ 9/ 27

STI0647

EXCEPT FOR Kro

¯

m MODELS

Use the following steps to mount the license

plate:

Before mounting the license plate, confirm that

the following parts are enclosed in the plastic

bag.

. License plate bracket

. J-nut 6 2

. Screw 6 2

. Screw grommet 6 2

1. Park the vehicle on flat, level ground.

2. Locate the center position

*

A

on the lower

part of the air duct. Measure straight down

from the edge where the bumper and air

duct meet to the aligning holes

*

B

, keeping

the tape measure lined up with the center

position.

3. Mark the holes

*

B

with a felt-tip pen.

4. Carefully drill the two aligning holes

*

B

using a 0.39 in (10 mm) drill bit at the

marked locations. (Be sure that the drill

only goes through the bumper fascia.)

5. Line up the bosses

*

C

or license plate

bracket with the holes and hold the license

plate bracket in place.

INSTALLING FRONT LICENSE PLATE

Technical and consumer information 9-11

1 2 ... 320 321 322 323 324 325 326 327 328 329 330 ... 344 345

Comments to this Manuals

No comments