Nissan 2011 Cube User Manual download pdf (Page 228)

Black plate (226,1)

Model "Z12-D" EDITED: 2010/ 9/ 27

chime sounds. The engine will start.

After step 3 is performed, when the ignition

switch is pushed without depressing the brake

pedal, the ignition switch position will change to

ACC.

NOTE:

. When the ignition switch is pushed to

the ACC or ON position or the engine is

started by the above procedures, the

Intelligent Key system warning light

may blink in yellow even if the Intelli-

gent Key is inside the vehicle. This is

not a malfunction. To stop the warning

light from blinking, touch the ignition

switch with the Intelligent Key again.

. If the Intelligent Key system warning

light in the meter is blinking in green,

replace the battery as soon as possible.

(See “KEY BATTERY REPLACEMENT”

in the “8. Maintenance and do-it-your-

self” section.)

. Make sure the area around the vehicle is

clear.

. Check fluid levels such as engine oil, cool-

ant, brake fluid, and window washer fluid as

frequently as possible, or at least whenever

you refuel.

. Check that all windows and lights are clean.

. Visually inspect tires for their appearance

and condition. Also check tires for proper

inflation.

. Lock all doors.

. Position seat and adjust head restraints.

. Adjust inside and outside mirrors.

. Fasten seat belts and ask all passengers to

do likewise.

. Check the operation of warning lights when

the ignition switch is placed in the ON

position. (See “ WARNING/INDICATOR

LIGHTS AND AUDIBLE REMINDERS” in

the “2. Instruments and controls” section.)

MODELS WITHOUT INTELLIGENT KEY

SYSTEM

1. Apply the parking brake.

2. Continuously Variable Transmission

(CVT) models:

Move the selector lever to the P (Park) or N

(Neutral) position. (P is recommended.)

The starter is designed so that it does not

operate unless the selector lever is in either

of the above positions.

Manual Transmission (MT) models:

Move the shift lever to the N (Neutral)

position. Depress the clutch pedal fully to

the floor.

The starter is designed not to operate unless

the clutch pedal is fully depressed.

3. Crank the engine with your foot off the

accelerator pedal by turning the ignition

switch to START. Release the switch when

the engine starts. If the engine starts, but

fails to run, repeat the above procedure.

— If the engine is very hard to start in

extremely cold weather or when restart-

ing, depress the accelerator pedal a little

(approximately 1/3 to the floor) and hold

it and then crank the engine. Release the

accelerator pedal when the engine

BEFORE STARTING THE ENGINE STARTING THE ENGINE

5-12 Starting and driving

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 344 345

Comments to this Manuals

No comments