Nissan 2012 GT R - Multi Function Display Owner's Ma User Manual download pdf (Page 214)

Black plate (214,1)

R35-N EDITED: 2010/ 12/ 2

8-4 Voice recognition

Useful tips for correct operation

It is possible to display useful speaking informa-

tion that may help the system to accept a voice

command correctly.

1. Highlight [Help on Speaking] and push

<ENTER>.

2. To confirm the page, scroll the screen using

the up and down switches of the main

directional buttons or the center dial.

USING VOICE RECOGNITION SYS-

TEM

Initialization

When the ignition switch is pushed to the ON

position, Voice Recognition is initialized, which

takes a few seconds. When completed, the

system is ready to accept voice commands. If

<

> is pushed before the initialization com-

pletes, the display will show the message:

“System not ready”.

BEFORE STARTING

To get the best recognition performance from

Voice Recognition, observe the following items.

. The interior of the vehicle should be as quiet

as possible. Close the windows to eliminate

the surrounding noises (traffic noise and

vibration sounds, etc.), which may prevent

the system from correctly recognizing the

voice commands.

. Wait until the tone sounds before speaking a

command.

. Speak in a natural conversational voice

without pausing between words.

GIVING VOICE COMMANDS

1. Push < > located on the steering wheel.

2. A list of commands appears on the screen,

and the system provides the voice menu

prompt “Would you like to access Phone,

Navigation, Information, Audio or Help?”.

3. After the tone sounds and the icon on the

screen changes from [

]to[ ], speak a

command.

4. Continue to follow the voice menu prompts

and speak after the tone sounds until the

preferred operation is completed.

Operating tips

. Speak a command after the tone.

. Commands that are available are always

shown on the display and spoken through

voice menu prompts. Commands other than

those that are displayed are not accepted.

Follow the prompts given by the system.

. If the command is not accepted, the system

announces, “Please say again”. Repeat the

command in a clear voice.

. Push <BACK> once to return to the

previous screen.

. To cancel the command, push and hold

<

>. The message, “Voice canceled” will

be announced.

. Push <

> to stop the voice prompt and

give the command at once. Remember to

wait for the tone before speaking.

. To adjust the volume of the system feed-

back, push the volume control buttons <+>

or <−> on the steering wheel or use the

audio system volume control knob while the

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 306 307

Comments to this Manuals

No comments