2009 MAXIMAQUICK REFERENCE GUIDESHIFT_performance
AIR RECIRCULATION BUTTON䡲 Press the air recirculation buttonto recirculate air inside the vehicle.䡲 To switch from air recirculation to fresh air inta
䡲 When the button is pressed while on the maximum speed, the speedreturns to the lowest fan speed.䡲 Press the AUTO buttonto return to automatic contro
DISC·AUX BUTTONPress the DISC·AUX button to play a CD loaded into the CD player. Press theDISC·AUX button again to play an iPod姞, if a compatible iPod
REAR AUDIO CONTROLS (if so equipped)The rear audio controls are located on the rear seat center armrest.To unlock or lock audio controls, push the REA
SEEK/CAT AND TRACK BUTTONS䡲 Press the SEEK/CAT button or the TRACK button while the CF card is being played;the next track or the beginning of the cur
RECORDING CDSThe system will not record MP3 or WMAfiles, only regular formatted CDs.1. Turn on the audio system and insert aCD.2. Touch the “REC” key.
SETTING MODEWhen the setting mode is selected, you are able to set reminders for alerts, maintenanceintervals or language displays.䡲 Press thebutton t
CLOCK SET/ADJUSTMENTNAVIGATION SYSTEM ONLY (if so equipped)Press the SETTING button, then select the“Clock” key using the NISSAN controllerand press t
AUTOMATIC DRIVE POSITIONER (if so equipped)The automatic driver positioner system hastwo features:䡲 Memory storage function.䡲 Entry/exit function.MEMO
CONTINUOUSLY VARIABLE TRANSMISSION (CVT)After starting the engine, fully depress the brake pedal. Move the shiftselector out of the P (Park) position.
TRIP COMPUTERHEADLIGHT AND TURN SIGNALCONTROLLOW TIRE PRESSURE WARNINGLIGHTVEHICLE INFORMATION DISPLAYINSTRUMENT BRIGHTNESS CON-TROL*WINDSHIELD WIPER/
䡲 When canceling the manual shift mode, return the shift selector to the D (Drive) modeposition. The transmission returns to the normal automatic driv
TIRE PRESSURE MONITORING SYSTEM (TPMS)This system monitors tire pressure. If the low tire pressure warninglight illuminates, check the tire pressure i
FUEL-FILLER CAP䡲 To tighten, turn the fuel-filler cap clockwise until ratch-eting clicks are heard. If the cap is not fully tightened,the service engi
MANUAL (if so equipped)䡲 The tilt and telescopic lock lever is located on thebottom of the steering column.䡲 Pull the tilt and telescopic lock leveran
DUAL PANEL MOONROOF (if so equipped)The ignition switch must be in the ON position to operatethe moonroof controls.SLIDING SUNSHADE AND MOONROOF䡲 When
Lumbar support (driver’s seat)Manual (if so equipped)䡲 Move the leverup or down to adjust the seatlumbar area.Power (if so equipped)䡲 Move the switchf
HOMELINK姞 UNIVERSAL TRANSCEIVER (if so equipped)SYSTEM OPERATING TIPS䡲 Garage doors, electrical gates, entry doors, etc. will be activated during prog
8. Your HomeLink姞 button should now be programmed. (To program the remainingHomeLink姞 buttons for additional door or gate openers, follow steps 2-8 on
PAIRING PROCEDURENOTE: The vehicle must be stationary when pairing the phone.1. Press thebutton on the steering wheel and wait for the tone.2. Say “Se
䡲 By Bluetooth姞 transfer - Say “Transfer entry”. The system acknowledges the com-mand and asks you to initiate the transfer from the phone handset. Th
TABLE OF CONTENTSNISSAN Intelligent Key™...2Automatic Door Locks ...3Windshield Wiper/Washer Swit
BLUETOOTH姞 HANDS-FREE PHONE SYSTEM (Navigation Systemonly – if so equipped)With an overhead microphone and soundtransmitted through the audio systemsp
PAIRING PROCEDURENOTE: The vehicle must be stationarywhen pairing the phone.1. Press the PHONE button on the con-trol panel or press thebutton onthe s
䡲 Transfer via Bluetooth - Transfers an entry from your cellular phone to the vehicle’sPhonebook. The sending procedure from the cellular phone varies
“DIAL” COMMAND ONLY䡲 You can say all the digits of a 7 or 10 digit phone number at one time.䡲 For a 10 digit number, saying the phone number in groups
Saying “Help” will display the User Guide explained later in this guide.Continue listening to the prompts and respond after the tone until the desired
“INTERNATIONAL CALL” COMMAND ONLY䡲 You can say the entire phone number at once or in groups of any digit length.䡲 For *, #, and +, say “STAR”, “POUND”
Setting a Destination to a Street Address1. Push theswitch on the steering wheel.2. The system responds with “Would you like to accessPhone, Navigatio
10. To begin route guidance, say “CALCULATEROUTE”. To confirm the destination location on themap before proceeding, say “SHOW MAP”.䡲 To improve recogn
4. Highlight [Alternate Command Mode] and press <ENTER>.5. To confirm the new mode, push theswitch.6. Verify that the screen changes to the one
NAVIGATION DISPLAY SCREEN䡲 Displays navigation features and map.DISABLED WHILE DRIVING䡲 Not all features can be manually oper-ated while the vehicle i
NISSAN INTELLIGENT KEY™The NISSAN Intelligent Key™ allows you to lock or unlock your vehicle,open your trunk and start the engine.NOTE: It is importan
DEST (DESTINATION) BUTTON䡲 Press the DEST button to displaythe address book and alternative waysof programming a destination.MAP BUTTON䡲 Press the MAP
BACK KEY / BUTTON䡲 Touch the “Back” key to return to theprevious function shown on the naviga-tion display or press the BACKbutton.VOICE BUTTON䡲 Press
BIRDVIEW™䡲 Displays the map in an elevated per-spective.SELECTING A MENU SCREEN1. To select a preferred menu key, touch the corresponding key on the s
䡲 Ensure the correct Region is selected.To change Region, touch the “ChangeRegion” key and select the appropriateRegion.䡲 Touch the “Street Address” k
䡲 Enter the house number; when finishedtouch the “OK” key. If you do not knowthe house number, touch the “NoHouse #” key.䡲 Enter the name of the stree
SETTING A DESTINATION䡲 Press the DEST button .䡲 Touch the “Points of Interest” key.䡲 Touch one of the Points of Interest keys.䡲 Touch the “By Name” ke
䡲 The selected destination is displayed atthe center of the map. Touch the “Start”key after confirming the location of thedisplayed destination. The s
MEMO
ACCESSORY MODE䡲 Press the START/STOP button once without depressing the brake pedal to access theACC mode. This position activates electrical accessor
MEMO
SHIFT_Nissan, the Nissan Brand Symbol, ⬙SHIFT_⬙ tagline, Z and Nissan model names are Nissan trademarks.© 2008 Nissan North America, Inc.QR9E-0A35U1 P
4. When activated, the hazard indicator will flash twice. When deactivated, the hazardindicator will flash once.5. The ignition switch must be placed
䡲 Turn the headlight control switch to the position to turn on the headlights. Allother lights remain on.FOG LIGHT OPERATION (if so equipped)NOTE: The
䡲 Press the volume control switch + or – to increase or decrease the volume.*iPod姞 is a trademark of Apple Inc., registered in the U.S. and other coun
PASSENGER’S SIDE TEMPERATURE CONTROL DIAL/DUAL MODE䡲 Press the passenger’s side temperature control dialto turn the passenger’sside temperature contro
Comments to this Manuals